Connect the rear brake actuating arm to the master cylinder
push rod with the joint pin, and secure the joint pin with the
washer and new cotter pin.
Hook the rear brake pedal return spring and brake light switch
spring to the actuating arm.
Install the brake light switch, switch stay and rear brake
master cylinder. Tighten the master cylinder mounting bolts
securely.
Connect the reservoir hose to the master cylinder with the
new O-ring and screw.
Install the right foot peg bracket. Tighten the mounting bolts.
TORQUE: 22 N'm (2.2 kg-m, 16 ft-Ibl
Install the muffler mounting bolt and nut.
TORQUE: 27 N'm (2.7 kg-m, 20 ft-Ibl
Connect the rear brake hose with the oil bolt and two new
sealing washers.
TORQUE: 30 N'm (3.0 kg-m, 22 ft-Ibl
Fill and bleed the rear brake system (page 14-3).
Check the brake light switch operation.
Operate the brake pedal to seat the caliper piston against the
pads.
REAR BRAKE CALIPER
REMOVAL
Drain the brake fluid from the hydraulic system.
Disconnect the brake hose from the caliper.
Remove the brake pads (page 14-6).
Remove the caliper mounting bolts and torque link bolt.
Remove the brake caliper.
HYDRAULIC BRAKE
(5) MOUNTING BOLi-s::'"
"
~(1)
PUSH ROD
14-15