Honda Hawk GT NT650 1988 Service Manual page 32

LUBRICATION
Install the outer rotor in the pump body with the punch mark
facing the cover, then install the inner rotor.
Install the drive pin and spacer on the shaft.
Install the shaft in the body, aligning the drive pin with the
inner rotor groove.
Install the dowel pin and a new gasket on the pump body, then
install the cover.
Tighten the cover bolts securely.
(1) OUTER ROTOR
(2) PUNCH MARK
(6)
INNER ROTOR
(1) OIL PUMP BODY
(2) OIL PUMP COVER
(1) COVER BOLTS
Install the O-rings, oil seal, oil strainer and oil pipe on the oil
pump.
CAUTION
Install the O-rings on the oil pipe with the tapered side facing
out as shown, or the engine will be damaged. .. ..
2-8
(1) OIL STRAINER
(5)
OIL'
SEAL
,
'(2)
O-RING