Honda Hawk GT NT650 1988 Service Manual page 233

ELECTRIC STARTER
Install the front shims in the same location and number as
before disassembly.
Install the a-ring on the case.
Install the lock washer, aligning its tabs with the slots of the
front cover.
Apply grease to the dust seal and install the front cover.
Align index marks of the front cover, case and rear cover as
shown.
Install and tighten the starter motor case screws and apply oil
to the a-ring and install it on the front cover.
INSTALLATION
(5) LOCK WASHER
(1)
ALIGN
(2)
a-RING
Install the starter motor in the engine.
Install and tighten the motor mounting bolts securely.
NOTE
• Install the ground cable with one mounting bolt as shown.
Connect the motor cable to the motor terminal and install the
rubber cap over the terminal.
Connect the battery negative cable.
STARTER RELAY SWITCH
OPERATION INSPECTION
Depress the starter switch button with the ignition switch ON.
The coil is normal if the starter relay switch clicks.
VOLTAGE INSPECTION
If you don't hear the switch "CLlCK", disconnect the switch
connector.
Shift the transmission into neutral and turn the ignition switch
ON.
Measure the voltage between the Yellow/Red
(+)
and Green/
Red (-) wires of the relay connector as you press the starter.
The tester should show battery voltage. If it does not, make
the following continuity inspection.
17-6