Honda Hawk GT NT650 1988 Service Manual page 187

Press the right pivot bearings out of the swingarm using a hy-
draulic press and the driver shaft.
Press the left pivot needle bearing out of the swingarm using a
hydraulic press and the special tool.
Apply clean grease to the new pivot bearings.
Press the right pivot bearing into the swing arm until it is flush
with the surface.
Apply clean grease to the pivot needle bearing.
Press the left needle pivot bearing into the swingarm until it is
flush with the surface.
TOOL:
Driver shaft
Driver handle
TOOL:
Driver shaft set
TOOLS:
Driver
Attachment. 32 x 35 mm
Pilot. 15 mm
TOOLS:
Driver
Attachment. 32 x 35 mm
Pilot. 22 mm
07746-MJ00100
or
07949-3710001
07746-MJOOOOO
07749-0010000
07746-0010100
07746-0040300
07749-0010000
07746-0010100
07746-0041000
I
I
I
i
REAR WHEEL/SUSPENSION
(1) DRIVER
SHAFT SET
(1) DRIVER
13-21