Honda Hawk GT NT650 1988 Service Manual page 110

Remove the rocker arms and wave washers from the shafts.
Inspect the rocker arm shafts and rocker arms for wear or
damage.
Check the rocker arms for clogged oil holes.
Measure the 0.0. of each rocker arm shaft.
SERVICE LIMIT:
IN/EX:
11.96
mm
(0.471
in)
Measure the 1.0. of each rocker arm.
SERVICE LIMIT: 12.03 mm (0.474 in)
CYLI NDER HEAD
REMOVAL
NOTE
• The cylinder head can be removed with the engine installed.
Drain the coolant (page 5-3) and remove the following:
- camshaft (page 9-3)
- exhaust pipes
California model only:
Remove the ASV pipes from the cylinder head.
Disconnect the clutch cable from the clutch lifter arm by re-
moving the clutch cable holder bolt.
Remove the oil pipe from the engine.
NOTE
• Do not bend the oil pipe during removal.
Remove the water pipes.
CYLINDER HEADIVALVES
I
1/
(2) ROCKER ARM SHAFT
9-7