Honda Hawk GT NT650 1988 Service Manual page 238

LIGHTS/METERS/SWITCHES
IGNITION SWITCH/METER
IGNITION SWITCH INSPECTION
Check for continuity between the ignition switch connector
terminals in each switch position.
Continuity should exsist between the color coded wires as
shown in the chart below.
BAT IG FAN TLl TL2 P
ON
~ ~ ~ ~ ~
~ ~ ~ ~ ~
OFF
P
COLOR R RIBI BulO Br/W Br Y/BI
REMOVAL
Disconnect the speedometer cable from the meter cover.
Remove the headlight.
Disconnect the meter harness connectors and ignition switch
connectors in the headlight case.
Remove the mounting bolts and meters.
(3) SPEEDO-
METER
HARNESS
(2)
6P BLACK::;J\
CONNECTOR
(1)
SPEEDOMETER
CABLE
'S8 Only:
Remove the mounting bolts and ignition switch.
After'S8:
Remove the (torx) mounting bolts using the special tool and
the ignition switch.
TOOL:
Torx bit
18-4
07703-0010100
or equivalent commercially
available in U.S.A.
After'SS:
a._-;;;;;;:-(1)
TORX BOLTS