Honda Hawk GT NT650 1988 Service Manual page 143

CRANKSHAFT/TRANSMISSION
Drive the countershaft bearing and oil seal out of the crank-
case.
Left crankcase
Remove the left mainshaft bearing using the special tools.
TOOLS:
Bearing remover set
- remover handle
- bearing remover set
- remover weight
07936-3710001
07936-3710100
07936 - 371 0600
07741-0010201
or
07936-3710200
U.S.A.
only
Install the new mainshaft bearing set plate on the left crank-
case.
NOTE
Install the new bearings with the following tools.
Apply fresh engine oil to the new crankcase bearings before
installation.
07749-0010000
07746-0010300
07749-0010000
07746-0010400
07746-0040600
TOOLS:
Left mainshaft bearing:
Driver
Attachment.
42
x
47
mm
Left countershaft bearing:
Driver
Attachment.
52 x 55
mm
Pilot.
25
mm
Install a new countershaft oil seal.
Check the gearshift spindle oil seal for wear or damage. re-
place if necessary.
(1) OIL SEAL
11-12