Spindle - Honda Hawk GT NT650 1988 Service Manual

Press the bearing and dust seal out of the cover with the spe-
cial tools.
Carefully press the new bearing in with the special tools.
TOOLS:
Driver
Attachment 52 x 55 mm
Pilot 35 mm
TOOLS:
Driver
Attachment 62 x 68 mm
Pilot 35 mm
Oil seal driver
Install the dust seal securely.
07749-0010000
07746-0010400
07746-0040800
07749-0010000
07746-0010500
07746-0040800
07965-KE80100
REAR WHEEL/SUSPENSION
(1)
DRIVER
SPINDLE
INSPECTION
Check the following of the spindle:
- splines for damage
- drive pins for damage
- lock nut threads for damage
If necessary, remove the brake disc retaining bolts and nuts
and lock nut, and separate the brake disc from the spindle.
Apply a locking agent to the drive pin bolt threads and tighten
the drive pin bolts to the drive pin if replaced them.
TORQUE: 15 N'm (1.5 kg-m, 11 ft-Ibl
Install the brake disc to the spindle and tighten the disc retain-
ing bolts and nuts.
TORQUE: 35 N'm 13.5 kg-m. 25 ft-Ib)
Install the disc retaining bolt lock nut onto the anywhere bolt.
TORQUE: 9 N'm (0.9 kg-m. 7 ft-Ib)
(1 )
RETAINING BOLTS
(4)
LOCK NUT
(2) BRAKE DISC (3) SPINDLE (5) DRIVE PIN/BOLT
13-11