Honda Hawk GT NT650 1988 Service Manual page 159

FRONT WHEEL/SUSPENSION/STEERING
Remove the distance collar from the wheel hub.
Remove the other bearing from the hub using the same tools.
Drive a new right bearing into the wheel until it is fully seated
first.
Install the distance collar into the wheel hub.
Drive a new left bearing into the wheel until it is fully seated.
• Do not allow the bearings to tilt while driving them in.
Never install an old bearing, once a bearing is removed, it
must be replaced with a new one.
07749-0010000
07746-0010300
07746-0040500
NOTE
TOOLS:
Driver
Attachment, 42
x
47 mm
Pilot, 20 mm
ASSEMBLY
NOTE
,
-
• The front wheel has no rim band.
-'-----------
• Do not get grease on the brake disc or stopping power will be
reduced.
(4)
SPEED-
OMETER
GEAR
BOX
(2)
BEARING
"IB~
(1)
DUST SEAL '
.-$iiiR
(3) SPEEDOMETER
RETAINER (5) BRAKE DISC
12-10