Lights/Meters/Switches - Honda C8R600F4 Service Manual

19. LIGHTS/METERS/SWITCHES
SERVICE INFORMATION
HEADLIGHT
TURN SIGNAL LIGHT
BRAKE/TAILLIGHT
LICENSE LIGHT
COMBINATION METER
SPEEDOMETER/SPEED SENSOR
TACHOMETER
COOLANT TEMPERATURE GAUGE/
THERMOSENSOR
COOLING FAN MOTOR SWITCH
SERVICE INFORMATION
GENERAL
19-1
19-3
19-3
19-4
19-5
19·6
19-8
19-9
19-9
19-11
OIL PRESSURE INDICATOR
19-12
IGNITION SWITCH 19-12
HANDLEBAR SWITCHES
19-13
BRAKE LIGHT SWITCH
19-14
CLUTCH SWITCH
19-15
NEUTRAL SWITCH
19-15
SIDE STAND SWITCH
19-15
LOW FUEL INDICATOR/
FUEL RESERVE SENSOR
19-16
HORN
19-17
TURN SIGNAL RELAY
19-18
• A halogen headlight bulb becomes very hot while the headlight is ON, and remains hot for a while after it is turned OFF.
Be sure to let it cool down before servicing.
• Use an electric heating element to heat the water/coolant mixture for the thermosensor inspection. Keep all flammable
materials away from the electric heating element. Wear protective clothing, insulated gloves and eye protection.
•Note the following when repladng the halogen headlight bulb.
-Wear clean gloves while replacing the bulb. Do not put finger prints on the headlight bulb, as they may create hot
spots on the bulb and cause it to fail.
If you touch the bulb with your bare hands, clean it with a cloth moistened with alcohol to prevent its early failure.
- Be sure to install the dust cover after replacing the bulb.
• Check the battery condition before performing any inspection that requires proper battery voltage.
•A continuity test can be made with the switches installed on the motorcycle.
•The following color codes used arc indicated throughout this section.
Bu: Blue G: Green Lg: Light Green R: Red
Bl: Black Gr: Gray 0: Orange W: White
Br: Brown Lb: Light Blue P: Pink Y: Yellow
m
1~-1