Honda Hawk GT NT650 1988 Service Manual page 63

FUEL SYSTEM
INSTALLATION
If the air tube joint was removed, install a new a-ring onto the
air tube joint.
Install the air cut off valve cover with the joint set plate and
tighten the screws securely.
Be sure the diaphragm and spring are properly seated.
Install the pilot screws and return them to their original posi-
tion as noted during removal.
Perform pilot screw adjustment if new pilot screws are in-
stalled (page 4-1 4).
NOTE
Do not install new plugs on new pilot screw holes until after
adjustment has been made.
If you replace the pilot screw in one carburetor, you must
replace the pilot screw in the other carburetor for proper
pilot screw adjustment.
FLOAT CHAMBER, FLOAT AND JETS
Install the pilot screw and turn it in until it seats lightly.
Turn the pilot screw out the number of turns recorded during
removal.
CAUTION
Damage to the pilot screw seat will occur
if
the pilot screw
is
tightened against the seat.
Install the valve seat, slow jet, needle jet and main jet.
Install the float with float valve in the carburetor body, then in-
stall the float arm pin through the body and the float.
4-10
O.
'7
0T
SCREW
/
(3)
SPRING