Honda Hawk GT NT650 1988 Service Manual page 60

Remove the float pin, float and float valves.
Check the float valve and valve seat for scratches, clogging or
damage.
Inspect the operation of the float valve.
FUEL SYSTEM
Remove the main jet, needle jet, slow jet and valve seat/filter.
Check each part for wear or damage.
Blow open all jets with compressed air.
Clean each jet with non-flammable or high flash point solvent.
Inspect the float valve seat and filter for grooves, nicks or de-
posits.
Clean the filter with low-pressure compressed air.
o
(5) FILTER-
(4) VALVE SEAT--
(2) MAIN
JET
/
' "
, (3) SLOW JET
PILOT SCREW REMOVAL
NOTE
The pilot screws are factory pre-set and should not be re-
moved unless the carburetors are overhauled.
The pilot screw plugs are factory installed to prevent pilot
screw misadjustment. Do not remove the plugs unless the
pilot screws are being removed.
Cover all openings with tape to keep metal particles out
when the plugs are drilled.
4-7