Honda Hawk GT NT650 1988 Service Manual page 82

ENGINE REMOVAL/INSTALLATION
SERVICE INFORMATION
GENERAL
• Support the motorcycle using a hoist, a floor jack or other adjustable support.
• The following parts can be serviced with the engine installed in the frame:
Clutch Alternator
Gearshift linkage Starter motor
Camshafts Carburetors
Cylinder head Water pump
• To service the crankshaft/transmission, oil pump, and cylinder the engine must be removed from the frame.
• When using the lock nut wrench, use a 20 inche long deflecting beam type torque wrench. The lock nut wrench increases
the torque wrench's leverage, so the torque wrench reading will be less than the torque actually applied to the lock nut.
SPECIFICATIONS
Engine dry weight
Oil capacity
Coolant capacity
TORQUE VALUES
Muffler mounting bolt
Exhaust pipe joint nut
Gearshift arm bolt
Drive sprocket bolt
Swingarm pivot nut
Swingarm pivot lock nut
Swingarm pivot adjusting bolt
Front engine bracket bolt
Front engine mouning bolt
Rear upper engine mouning bolt
- mounting bolt lock nut
- mounting bolt adjusting bolt
Fuel tank mounting bolt: Front
: Rear
TOOL
Special
Lock nut wrench
6-2
61 kg (1341bl
2.8 lit (2.94 US qt, 2.46 Imp qt) at disassembly
2.0 lit (1.89 US qt, 2.27 Imp qt) total
27 N·m (2.7 kg-m, 20 ft-Ibl
27 N'm (2.7 kg-m, 20 ft-Ib)
12 N'm (1.2 kg-m, 9 ft-Ibl
10 N'm (1.0 kg-m, 7.2 ft-Ib)
65 N'm (6.5 kg-m, 47 ft-Ibl
65 N'm (6.5 kg-m, 47 ft-Ibl
15 N'm (1.5 kg-m, 11 ft-Ibl
28 N'm (2.8 kg-m, 20 ft-Ibl
40 N'm (4.0 kg-m, 29 ft-Ibl
40 N'm (4.0 kg-m, 29 ft-Ibl
55 N'm (5.5 kg-m, 40 ft-Ibl
11 N'm (1.1 kg-m, 8 ft-Ib)
12 N'm (1.2 kg-m, 9 ft-Ib)
22 N'm (2.2 kg-m, 13 ft-Ibl
,
.
07908 - ME90000