Honda Hawk GT NT650 1988 Service Manual page 91

CLUTCH/GEARSHIFT LINKAGE
Check the needle bearings for wear or damage or a loose fit in
the cover.
Check the dust seal for fatigue or damage.
Apply grease to the dust seal and needle bearing.
Install the clutch lifter shah, snap ring and return spring.
Hook the spring end in the cover tab securely, and turn the
shaft.
Install the clutch lifter piece, aligning the piece end with the
groove in the clutch lifter shaft.
CLUTCH REMOVAL
Remove the following:
- clutch bolts
- clutch lifter plate
- springs
NOTE
• Remove the bolts in a crisscross pattern in 2 or 3 steps.
• Be careful not to damage the shah threads.
Unstake the clutch lock nut with a drill or grinder.
7-4
•
NOTE