Honda Hawk GT NT650 1988 Service Manual page 163

FRONT WHEEL/SUSPENSION/STEERING
Remove the dust seal and the stop ring with a screwdriver.
CAUTION
• Do not scratch the fork lube sliding surface.
Pull the fork tube out until resistance from the slider bushing is
felt. Then move it in and out, tapping the bushing lightly until
the fork tube separates from the slider. The slider bushing will
be forced out by the fork tube bushing.
Remove the oil lock piece from the piston.
Remove the piston and rebound spring from the fork tube.
Remove the oil seal, back-up ring and slider bushing from the
fork tube.
NOTE
Do not remove the fork tube bushing unless it is necessary
to replace it with a new one. See bushing inspection, page
12-15.
12-14
(2) STOPPER RING
(2) FORK TUBE
(1) PISTON
/
/
(2) OIL LOCK PIECE
(2) BACK-UP RING
I
7
(4) FORK TUBE BUSHING