FUEL SYSTEM
Install the vacuum piston, aligning the tab of the diaphragm
with the groove of the carburetor.
Install the chamber cover with the spring, aligning the cover
with the hole in the carburetor, and secure with at least two
screws before releasing the vacuum piston.
Install the fuel tubes as shown.
CARBURETOR
SEPARATION/ASSEMBLY
SEPARATION
Loosen the synchronization adjusting screw.
NOTE
When separating the carburetors, be careful not to lose the
thrust spring and synchronization adjusting spring.
Separate the carburetors by removing the two attaching
screws.
Remove the synchronization spring.
4-12
(1) CHAMBER COVER
j