Honda Hawk GT NT650 1988 Service Manual page 83

ENGINE REMOVAL
Place the motorcycle on its center stand.
Drain the engine oil (page 2-3).
Drain the coolant (page 5-3).
Disconnect the battery negative cable from the battery termi-
nal.
Remove the following:
- fuel tank (page 4-3l.
- air cleaner case (page
4-4).
- carburetor (page 4-5l.
- radiator (page
5-5).
- exhaust pipe and muffler (page 13-24).
Remove the gearshift arm from the gearshift spindle.
Loosen the drive chain (page 3-12).
Remove the drive sprocket cover (page 8-2), then remove the
sprocket from the drive chain by removing two sprocket bolts
and the plate.
Disconnect the following electrical connections:
- oil pressure switch wire.
- neutral switch wire.
- pulse generator wire.
- alternator wire.
- starter moter cable and ground cable.
Disconnect the following cooling system connections:
- water hoses to thermostat housing at the engine.
- siphon tube at the filler neck.
Remove the thermostat housing with water hoses attached:
Disconnect the clutch cable from the clutch lifter arm by re-
moving the holder bolt.
Remove the swingarm pivot nut.
ENGINE REMOVAL/INSTALLATION
.--
~
--- . . ' (1) EXHAUST PIPE AND MUFFLER
~
-
6-3