Honda Hawk GT NT650 1988 Service Manual page 90

RIGHT CRANKCASE COVER REMOVAL
Drain the engine oil (page 2-3).
Remove the exhaust pipe.
Remove the clutch cable holder and disconnect the clutch
cable from the clutch lifter arm.
Loosen the oil pipe holder and remove the oil pipe bolt and seal-
ing washers from the right crankcase cover.
Remove the right crankcase cover bolts and cover.
NOTE
R. crankcase cover can be serviced with rear exhaust pipe
removal only.
Remove the dowel pins and gasket.
Remove the oil orifice.
CLUTCH LIFTER
Remove the clutch lifter piece. and remove the snap ring and
return spring from the right crankcase cover.
Remove the clutch lifter shaft.
Check the clutch lifter piece and shaft for damage or excessive
scratching.
Check the return spring for fatigue or damage.
CLUTCH/GEARSHIFT LINKAGE
(2) L1FTER/
SHAFT
7-3