Honda Hawk GT NT650 1988 Service Manual page 201

Remove the boot.
Remove the piston and spring by removing the snap ring.
TOOL:
Snap ring pliers 07914-3230001
or equivalent commercially
available in U. S. A.
HYDRAULIC BRAKE
(1) SNAP RING
Clean the inside of the master cylinder, reservoir, spring and
piston with clean brake fluid.
INSPECTION
Measure the master cylinder I. D.
SERVICE LIMIT: 12.76 mm (0.502 in)
Check the master cylinder for scores, scratches or nicks.
Measure the master piston
0.0.
at the location shown.
SERVICE LIMIT: 12.65 mm (0.498 in)
Check the primary and secondary cups for damage before as-
sembly.
ASSEMBLY
CAUTION
• Handle the master cylinder piston, cylinder and spring as a set.
Coat all parts with clean brake fluid before assembly.
Install the spring in the master .cylinder with its large diameter
facing inside.
Install the piston.
CAUTION
When installing the piston, do not allow the cup lips to turn
inside out.
(4) SNAP RING
~
(3)PISTON~
(2) SPRING
(1) MASTER
CYLINDER--::!$~
(2) MASTER CYLINDER
/
A
(4) SNAP RING
II
f@/
(3)
PISTON~,
(2) SPRING
(1) MASTER CYLINDER
14-9