Honda Hawk GT NT650 1988 Service Manual page 199

Position the pad spring in the caliper as shown.
Push the piston all the way in to allow installation of new brake
pads.
NOTE
Check the brake fluid level in the reservoir as this operation
causes the level to rise.
Insert the new brake pads.
Install the pad pin by pushing the pads against the caliper to
depress the pad spring.
Install the caliper onto the brake disc so the disc is positioned
between the pads. being careful not to damage the pads.
Install the caliper pivot bolt and tighten it.
,
.
TORQUE: 22 N'm (2.2 kg-m. 16 ft-Ibl
Tighten the pad pin.
TORQUE: 17 N'm (1.7 kg-m. 12 ft-Ibl
Install the pad pin plug.
TORQUE: 2.5 N'm (0.25 kg-m. 1.8 ft-Ibl
Operate the brake pedal to seat the caliper piston against the
pads.
HYDRAULIC BRAKE
14-7