Static Route, Static Arp And Rip Configuration; Configure Static Routes - D-Link DES-3326SR Manual

Static Route, Static ARP and RIP Configuration

Configure Static Routes

Configure Static ARP
Routing Information Protocol (RIP) Configuration
This chapter describes how to configure static routes, create permanent entries for the ARP table, and set up RIP.
For more information on static routes (IP routing) ARP and RIP, please read Appendix C.
Configure Static Routes
Entries into the Switch's forwarding table can be made using both MAC addresses and IP addresses. Static IP
forwarding is accomplished by the entry of an IP address into the switch's Static IP Routing table. Static routes
that have been previously configured appear in the Static/Default Route Settings table.
To enter an IP address into the Switch's IP Forwarding Table, open the Forwarding Folder and then the IP
Forwarding folder, and the click the Static/Default Routes link:
To delete an existing static/default route, select the route and the click the Delete button.
To add a new static/default route, click the New button:
D-Link DES-3326SR Layer 3 Switch
Figure 22- 1. Static/Default Routes
Figure 22- 2. Static/Default Routes – Add
152
Chapter 22