How To Read The Parameter List; Icons And Terms That Identify Parameters And Control Modes - YASKAWA GA800 Programming Manual

1.2

How to Read the Parameter List

◆

Icons and Terms that Identify Parameters and Control Modes

Icon
V/f
The parameter is available when operating the drive with V/f Control.
CL-V/f
The parameters is available when operating the drive with Closed Loop V/f Control.
OLV
The parameter is available when operating the drive with Open Loop Vector Control.
CLV
The parameter is available when operating the drive with Closed Loop Vector Control.
AOLV
The parameter is available when operating the drive with Advanced Open Loop Vector Control.
OLV/PM OLV/PM
The parameter is available when operating the drive with Open Loop Vector Control for PM.
AOLV/PM
The parameter is available when operating the drive with Advanced Open Loop Vector Control for PM.
CLV/PM
The parameter is available when operating the drive with Closed Loop Vector Control for PM.
EZOLV
The parameter is available when operating the drive with EZ Open Loop Vector Control.
Hex. Hexadecimal numbers that represent MEMOBUS addresses to change parameters over network communication.
RUN The parameter can be changed settings during run.
Expert The parameter that is available in Expert Mode only.
*1 Set A1-01 = 3 [Access Level Selection = Expert Level] to display and set Expert Mode parameters on the keypad.
Note:
Gray icons identify parameters that are not available in the specified control method.
YASKAWA TOEPYAIGA8002B GA800 Drive Programming
Description
*1

1.2 How to Read the Parameter List

1
17