Testing Automatic Detectors - Siemens AlgoPilot B3Q661 Operating Instructions Manual

Testing AUTOMATIC DETECTORS

The system must be switched to test mode before testing can begin.
Switching over
F
to test mode
Also refer to following chapter:
· "TEST CONDITION per SECTION" on page 42
· "TEST CONDITION per LINE" on page 44
· "TEST CONDITION per ZONE" on page 46
This procedure describes the test principle for automatic detectors.
Testing auto-
matic detectors
Perform the following steps to test automatic detectors:
Step
NOTE:
Once testing is complete, the 'Test condition' operating mode must be ended.
+
Also refer to following chapter:
· "TEST CONDITION per SECTION" on page 42
· "TEST CONDITION per LINE" on page 44
· "TEST CONDITION per ZONE" on page 46
Building Technologies
Fire Safety
Action
Set corresponding detector to
1
'Test condition' operating mode.
Attach detector tester to detector.
2
Note marking!
· The detector exchanger and
detector tester DZ1193 is
needed for AlgoRex smoke de-
tectors and neural smoke de-
tectors.
· The detector tester RE6T is
needed for AlgoRex heat de-
tectors:
The rise in temperature is simu-
lated using a hot air fan.
· The detector exchanger and
tester FDUD292 is needed for
TM
Sinteso devices
Wait until the response indicator
3
on the detector flashes.
Remove detector tester.
4
Operating instructions Œ•Ž
Result / Comment
AlgoRex
DOT
DT
DO
Detector exchanger and tester Detector test-
er Detector exchanger and tester
DZ1193 RE6T
The function test is complete.
Continue with the next detector.
A6V10225450_b_en_--
TM
Sinteso
FDO, FDOOT
FDT
FDM, FDS
FDC, FDL
FDUD292
47
2017.09.07