Blocking Operation (Logging Out) - Siemens AlgoPilot B3Q661 Operating Instructions Manual

BLOCKING OPERATION (logging out)

You only need to explicitly log out if you logged in with the key.
Introduction
If you logged in with a password, you don't necessarily need to explicitly log out because you
will be automatically logged out after a certain period (timeout).
You may however log out explicitly if you want.
You can only log out using the <Õ> button in the primary menu. If any other menu (from any
Precondition:
menu, sub-menu or main menu) is displayed, you first need to return to the primary menu.
Return to pri-
Perform the following steps to return to the primary menu:
mary menu
Step
This brings about explicitly logging out as follows:
Logging out us-
ing <Õ> button
NOTE: Only possible if the key is in a horizontal position!
Step
Perform the following steps to log out with a key switch:
Logging out us-
ing key switch
NOTE: Only possible if you gained access using the key switch.
Step
Building Technologies
Fire Safety
ALARM
.
.
.
.
.
.
.
.
Alarms
Alarm device
active
Remote alarm
active
Alarm delay
off
Action
1
Press <Õ>
Action
•
1
Press <Õ>
Action
Ž
1
Turn key
to vertical position
2
Remove key
l:
01 Unmanned
Faults
Alarm device Alarm device
fault off
Remote transmission Remote alarm
off
fault
System Detector
fault test mode
Result / Comment
ΠThis takes you straight to the primary
button
menu from any other menu.
'<X] button to log out ' appears
on the display.
Result / Comment
Logging out is complete.
button
Result
Logging out is complete.
Ž
Operating instructions Œ•Ž
1
Silence buzzer
1
Acknowledge
Reset
Information
1 2 3
4 5 6
Premises
3
manned
System
7 8 9
on
0
2
A6V10225450_b_en_--
25
2017.09.07