Siemens AlgoPilot B3Q661 Operating Instructions Manual page 45

TEST CONDITION per LINE,
Perform the following steps to set all the detector zones of a LINE to 'Test condition' operating
Switching on
mode:
'Test condition'
operating mode
Step
Perform the following steps to end 'Test condition' operating mode for all detector zones of a
Ending 'Test
LINE:
condition'
operating mode
Step
Building Technologies
Fire Safety
Action
Navigate to the LINE you want us-
1
ing:
<Operate..>
<Browse..>
< HARDWARE level..>
<Lower level¯>
( <Lower level¯>
<More functions..>
<More functions..>
Press softkey
2
<Detector line -> TEST>
Action
Navigate to the LINE you want us-
1
ing:
<Operate..>
<Browse..>
< HARDWARE level..>
<Lower level¯>
( <Lower level¯>
<More functions..>
<More functions..>
Press softkey
2
<Detector line -> TEST OFF>
continued
Result / Comment
t
t
t
t
(The number of 'Lower level' com-
mands to be executed depends on
)
t
the type of line board)
t
The line functions are displayed
Implementation messages
'Implementing ...'
'Implemented'
Result / Comment
t
t
t
t
(The number of 'Lower level' com-
) mands to be executed depends on
t
the type of line board)
t
The line functions are displayed
Implementation messages
'Implementing ...'
'Implemented'
Operating instructions Œ•Ž
- and -
- and -
A6V10225450_b_en_--
2017.09.07
45