Test Condition Per Line - Siemens AlgoPilot B3Q661 Operating Instructions Manual

TEST CONDITION per LINE

This function is used to test all zones of a specific detector line, i.e. all zones with devices which
What does 'per
are linked physically with this specific line, are set to the 'Test condition' operating mode with
LINE' mean?
one single command.
All appropriate zones, which are linked to devices on the line selected, are switched into test
How does it
mode.
work?
F
NOTE
For general information about the 'Test condition' operating mode, see chapter "TEST
CONDITION per SECTION" on page 42.
If you still don't have operating access when starting operation work, the release procedure is
Operating ac-
automatically called up.
cess
44
Building Technologies
Fire Safety
Operating instructions Œ•Ž
A6V10225450_b_en_--
2017.09.07