Switching All Zones In A Section Off/On - Siemens AlgoPilot B3Q661 Operating Instructions Manual

Switching ALL ZONES in a SECTION OFF/ON

F
For general information about switching zones off/on, see chapter
i
"Switching INDIVIDUAL ZONE OFF/ON" on page 28
F
Switching -
The steps are similar to those for the individual zone, see chapter
OFF/ON with
"Switching INDIVIDUAL ZONE OFF/ON (with time limit)" on page 30
time limit
The following description assumes you are using an 'automatic detector' zone type; the
Zone type
procedure applies likewise to the 'manual call point' zone type.
If you still don't have operating access when starting operation work, the release procedure is
Operating ac-
automatically called up.
cess
You can use this command to switch OFF all the detectors in a section. Perform the following
Switching OFF
allzones in a steps:
section
Step
32
Building Technologies
Fire Safety
Action
Press softkey
1
<Operate..>
Press softkey
2
<Browse..>
Press softkey
3
<Browse FIRE DETECTION..>
Press softkey
4
<Select SECTION¯>
Press softkey
5
<DETECTOR zone functions..>
Press softkey
6
<All DETECTOR zones -> OFF>
Operating instructions Œ•Ž
Result / Comment
The main menu appears on the dis-
play.
The sub-menu is displayed.
The AREAS menu is displayed
Use the scroll keys to select the ar-
ea you want.
The SECTIONS menu is displayed
Use the scroll keys to select the
section you want.
The sub-menu is displayed.
Implementation messages
'Implementing ...'
'Implemented'
A6V10225450_b_en_--
- and -
2017.09.07