Replacing Sinteso; Tm Device - Siemens AlgoPilot B3Q661 Operating Instructions Manual

REPLACING Sinteso

Simple replace-
The process of replacing Sinteso
ment process
TM found, it can be replaced by a new device of the same type.
for Sinteso
devices
If you still don't have operating access when starting operation work, the release procedure is
Operating ac-
automatically called up.
cess
The command is available at zone level. A message to this effective is displayed on the termi-
nal. Only one element can be replaced per replacement session.
Test condition -
> On operating
mode
Perform the following steps to set a defective Sinteso
mode:
Step
· The corresponding zone is switched to 'Test'.
NOTE
· Replace defective device with one of the same type in the FDnet.
· The AI in the device flashes for a few seconds (only if the device type is the same).
· Once this command has been executed, the message
appears.
· Once the test condition has been completed, the zone must be reset to normal operation us-
ing the 'Zone -> Test condition off' command, as described on the next page.
68
Building Technologies
Fire Safety
TM
DEVICE
Action
Press softkey
1
<Functions for sel. message..>
Press softkey
2
<Select ZONE>
Press softkey
3
<TEST/RENOVATION/INST.TEST
funct..>
Press softkey
4
<Zone ->TEST>
TM
devices is a simple one. Once the defective device has been
TM
Change in hardware configuration
Operating instructions Œ•Ž
detector to 'Test condition' operating
Result / Comment
Implementation messages
'implementing ...'
Implementation messages
'implementing ...'
A6V10225450_b_en_--
2017.09.07