Safety-Relevant Working Instructions - Siemens AlgoPilot B3Q661 Operating Instructions Manual

Example of an indication of danger:
Example

Safety-relevant working instructions

The products are developed and produced in compliance with the relevant international and Eu-
Country-specific
ropean safety standards. Should additional country-specific, local safety standards or regulations
standards
concerning planning, assembly, installation, operation and disposal of the product apply in the
place of operation, then these standards or regulations must also be taken into account in addi-
tion to the safety regulations mentioned in the product documentation.
Work on electrical installations may only be carried out by a qualified electrician or by an instruct-
Electrical instal-
ed person working under the guidance and supervision of a qualified electrician, in accordance
lations
with the electrotechnical regulations.
· Control panels must be disconnected from the power supply during commissioning or mainte-
nance work whenever possible.
· Connection terminals with an external voltage supply must be provided with a sign reading
'DANGER – External voltage'.
· Mains leads to the control panel must be installed separately and provided with a clearly
marked fuse.
· Earthing must be carried out in compliance with local safety regulations.
· When work is carried out in explosion-hazardous areas, the appropriate safety precautions
must be taken.
· If any tools or accessories such as ladders are required, safe and suitable devices must be
Assembly, in-
used.
stallation, com-
· Spurious activation of the remote transmission must be reliably prevented.
missioning and
· Always inform the fire brigade before testing the remote transmission.
inspection work
· The activation of fire controls for test purposes must not cause damage to the system or parts
thereof.
· Fire controls must only be activated after the test has been completed and the system has
been definitely handed over to the customer.
· Third party systems or devices must only be activated in the presence of the responsible per-
son.
· When work on management stations and system terminals is performed, the safety regulations
of the connected sub-systems must be observed. This especially applies when switching off
system components.
· In the case of extinguishing systems, always use the "General installation instructions" as a
guideline. These guidelines are available on request.
Building Technologies
Fire Safety
DANGER! External voltage
Disconnect the component from the power supply.
General information i
11
A6V10225450_b_en_--
2017.09.07