Touch Operation - Siemens SINUMERIK HT 10 Equipment Manual

Description

2.5 Touch operation

HT 10 operated with a handwheel
An HT 10 with a handwheel behaves in the same way as an MCP 483C PN (in Ethernet mode)
with a handwheel. The handwheel pulses are transmitted via Ethernet to the NCK in the HT 10
MCP process image.
NOTICE
Lack of care for traversing can cause damage to the tool/workpiece
A handwheel on a mobile HT 10 has 50 increments per revolution. There are 100 increments/
revolution on a stationary device. This difference results in traverse paths of differing lengths.
See also
Representation (Page 15)
2.5 Touch operation
The HT 10 is operated by touching the touch-sensitive glass surface with fingers or gloves
(projected capacitive) or with a touch pen for capacitive user interfaces:
• Depending on the application-specific functions shown in the display area, for example, by:
– pressing a softkey or a displayed button
– Gestures with up to 5 fingers
Unexpected machine movements caused by incorrect operation
Incorrect operation of devices with a touch screen can lead to unexpected machine
movements. This can result in death, serious injury and material damage.
• Prevent unintentional incorrect operation by appropriate configuration of the user
• Configure the machine so that safety-related functions are not operated with the touch
20
WARNING
interface, e.g. by placing the buttons for starting and stopping machine components far
enough apart.
screen.
Handheld Terminal HT 10
Equipment Manual, 09/2020, A5E47430965B AA