Chrysler Concorde 2004 Service Manual page 1472

5 - 6 BRAKES - BASE BRAKE SYSTEM
BRAKES - BASE BRAKE SYSTEM (Continued)
NOTE: Monitor the brake fluid level in the fluid res-
ervoir periodically to make sure it does not go too
low. This will ensure that air does not reenter the
brake hydraulic system.
(7) Bleed the remaining wheel circuits in the same
manner until all air is removed from the brake
hydraulic system.
(8) Check brake pedal travel. If pedal travel is
excessive or has not improved, some air may still be
trapped in the hydraulic system. Rebleed the brake
system as necessary.
(9) Reinstall all 4 bleeder screw dust caps.
(10) Test drive vehicle to ensure brakes are oper-
ating properly and pedal feel is correct.
SPECIFICATIONS
BRAKE COMPONENTS
DESCRIPTION
Brake Hydraulic System
Brake Pedal Ratio
Brake Tube Fitting Type
Master Cylinder Type -
with ABS
Master Cylinder Type -
without ABS
Master Cylinder
Bore/Stroke
Master Cylinder Split
Master Cylinder Outlet
Port Primary Tube Nut
Thread
Master Cylinder Outlet
Port Secondary Tube Nut
Thread - W/ABS
Master Cylinder Outlet
Port Secondary Tube Nut
Thread - W/O ABS
Power Brake Booster
Type
Power Brake Booster
Boost
SPECIFICATION
Dual Circuit - Diagonally
Split
3.44:1
ISO Flares
Center Valve (Port)
Vent Port
23.8 mm x 39.4 mm
(0.937 in. x 1.55 in.)
50/50
M-12
M-10
M-12
205 mm Vacuum Assist
4690 At 20 inches
Manifold Vacuum
BRAKE FASTENER TORQUE
DESCRIPTION
Brake Hose Intermediate
Bracket Bolt
Caliper Banjo Bolt
Caliper Bleeder Screw
Caliper Guide Pin Bolts
Junction Block Support
Bracket Bolts
Master Cylinder Mounting
Nuts
Parking Brake Lever
Mounting Bolts
Power Brake Booster
Mounting Nuts
Tube Nuts
Wheel Mounting (Lug) Nuts
LH
Ft. In.
N·m
Lbs. Lbs.
12 — 105
48 35 —
15 — 125
22 16 192
26 19 230
28 21 250
28 21 250
28 21 250
17 — 145
135 100 —