Chrysler Concorde 2004 Service Manual page 1466

Hide thumbs Also See for Concorde 2004:

Table of Contents

CV BOOT-OUTER (Continued)

Fig. 35 Sealing Boot Retaining Clamp Installed

1 - SEALING BOOT

2 - SPECIAL TOOL C-4975

3 - CLAMP BRIDGE

(7) Clamp sealing boot onto outer C/V joint hous-

ing using Crimper, Special Tool C-4975 and the fol-

lowing procedure. Place crimping tool C-4975 over

bridge of clamp (Fig. 36). Tighten nut on crimping

tool C-4975 until jaws on tool are closed completely

together, face to face (Fig. 37).

Fig. 36 Crimping Tool Installed On Sealing Boot

1 - SPECIAL TOOL C-4975

2 - SEALING BOOT

3 - CLAMP BRIDGE

Fig. 37 Sealing Boot Retaining Clamp Installed

1 - BOOT CLAMP

2 - SPECIAL TOOL C-4975

3 - SEALING BOOT

4 - OUTER C/V JOINT

(8) Install the driveshaft requiring boot replace-

ment back on the vehicle. (Refer to 3 - DIFFEREN-

DRIVELINE/HALF

INSTALLATION)

Chapters

Table of Contents

300m 2004 Intrepid 2004