Chrysler Concorde 2004 Service Manual page 1463

LH
CV BOOT-INNER (Continued)
Fig. 25 Spider Assembly Retaining Snap Ring
1 - SNAP RING
2 - SEALING BOOT
3 - SPIDER ASSEMBLY
4 - SNAP RING PLIERS
5 - INTERCONNECTING SHAFT
Fig. 26 Spider Assembly Installed in Housing
1 - INTERCONNECTING SHAFT
2 - SPIDER ASSEMBLY
3 - TRIPOD JOINT HOUSING
(6) Install inner tripod joint seal boot to intercon-
necting shaft clamp evenly on sealing boot.
(7) Clamp sealing boot onto interconnecting shaft
using Crimper, Special Tool C-4975 and the following
procedure. Place crimping tool C-4975 over bridge of
clamp (Fig. 27). Tighten nut on crimping tool C-4975
until jaws on tool are closed completely together, face
to face (Fig. 28).
Fig. 27 Crimping Tool Installed On Sealing Boot
1 - SPECIAL TOOL C-4975
2 - SEALING BOOT CLAMP
3 - INTERCONNECTING SHAFT
4 - SEALING BOOT
Fig. 28 Sealing Boot Retaining Clamp Installed
1 - SEALING BOOT
2 - SPECIAL TOOL C-4975
3 - CLAMP BRIDGE
CAUTION: Seal must not be dimpled, stretched or
out of shape in any way. If seal is NOT shaped cor-
rectly, equalize pressure in seal and shape it by
hand.
(8) Position the sealing boot into the tripod hous-
ing retaining groove (Fig. 29). Install seal boot
retaining clamp evenly on sealing boot.
(9) Clamp sealing boot onto tripod housing using
Crimper, Special Tool C-4975 and the following pro-
cedure. Place crimping tool C-4975 over bridge of
clamp. Tighten nut on crimping tool C-4975 until
jaws on tool are closed completely together, face to
face.
HALFSHAFT 3 - 11
Clamp