Chrysler Concorde 2004 Service Manual page 1460

Hide thumbs Also See for Concorde 2004:

Table of Contents

HALFSHAFT (Continued)

Fig. 17 Installing Brake Rotor

2 - STEERING KNUCKLE

3 - BRAKE ROTOR (DISC)

4 - WHEEL MOUNTING STUD

Fig. 18 Disc Brake Caliper Mounting

1 - BRAKE SHOES

2 - STEERING KNUCKLE

3 - BRAKING DISC

4 - CALIPER ASSEMBLY

5 - MACHINED ABUTMENT

(12) Install wheel and tire assembly on vehicle.

Tighten the wheel mounting stud nuts in proper

sequence (Fig. 19), until all nuts are tightened to half

specification. Then repeat the tightening sequence to

the full specified torque of 135 N·m (100 ft. lbs.).

Fig. 19 Tightening Wheel Nuts

(13) Lower vehicle to the ground.

CAUTION: When tightening hub and bearing assem-

bly to stub shaft retaining nut, do not exceed the

maximum torque of 142 N·m (105 ft. lbs.). If the

maximum torque is exceeded this may result in a

failure of the driveshaft.

(14) Apply the vehicle's brakes to keep vehicle

from moving. Tighten the NEW stub shaft to hub

and bearing assembly retaining nut to 142 N·m (105

ft. lbs.) (Fig. 20).

Fig. 20 Tighten Hub And Bearing Retaining Nut

1 - HUB/BEARING

2 - TORQUE WRENCH

Chapters

Table of Contents

300m 2004 Intrepid 2004