Completing The Remote Office 9150 Forms - Nortel Remote Office 9150 Installation And Administration Manual

Planning forms

Completing the Remote Office 9150 forms

This section briefly describes how to complete the Remote Office 9150
configuration forms.
To complete the forms
1 Assign each user telephone or fax machine to a port on the Remote Office
9150 unit.
Record the assignments on the Remote Office 9150 Configuration
Information—Stations form. Designate each port as a local port, remote
port, or local and remote port.
2 Use the information you received from the ISDN service provider for the
Remote Office 9150 site to complete the Remote Office 9150 Configuration
Information—ISDN BRI Modules form.
At the same time, do the following:
a. Designate a B-channel as a primary trunk. The Remote Office 9150
Note: The primary trunk on the Remote Office 9150 unit is defined as
follows:
n the lowest-numbered B-channel defined as Remote only
n the lowest-numbered B-channel defined as Local and Remote
b. Assign B-channels to trunk groups. Record the assignments on the
344
unit uses primary trunk to establish connections between the Remote
Office 9150 unit and the RLC.
Do not include the primary trunk in any trunk groups. Nortel Networks
recommends that you define the primary trunk as Remote only.
Record the primary trunk assignment in the "Connection to RLC
information" section on the Remote Office 9150 Configuration
Information—Network Connections form.
ISDN BRI Modules form.
Standard 2.0
Remote Office 9150