Nortel Remote Office 9150 Installation And Administration Manual page 141

September 2001
To connect the Remote Office 9150 unit to the network
. W
1 Connect the male 50-pin connector of the telephone cable to the TELCO 1
connector on the Remote Office 9150 unit.
Secure the cable connection by snapping the wire tabs into place or by
inserting screws.
2 Refer to the pin-out table in "TELCO 1 connector pin-out table" on page 374
(in Appendix C) for establishing the connections to the telephones and
trunks.
3 If you want to route calls over the IP network, or administer the Remote
Office 9150 unit from another location on the IP network, connect the
Remote Office 9150 unit to the Ethernet network by doing the following:
a. Connect one end of the RJ-45 Ethernet cable to the ETHERNET
b. Connect the other end to an Ethernet hub.
4 Connect the male 50-pin connector of the other telephone cable to the
TELCO 2 connector on the Remote Office 9150 unit.
Secure the cable connection by snapping the wire tabs into place or by
inserting screws.
5 Refer to the pin-out table in "TELCO 2 connector pin-out table" on page 376
(in Appendix C) to establish the connections to the telephones and trunks.
Installation and Administration Guide
WARNING
Risk of electric shock or damage to equipment
To reduce the risk of electric shock to yourself or damage to
the Remote Office 9150 unit, ensure that the power source to
the unit is turned off until the Telco 1 and Telco 2 connections
have been completed.
connector on the Remote Office 9150 unit.
Installing the Remote Office 9150 unit
117