Nortel Remote Office 9150 Installation And Administration Manual page 165

September 2001
3 Ensure that the placement of ISDN BRI modules within the Remote Office
9150 unit correspond with the Telco 1 and Telco 2 cable connections.
Note: Refer to the Telco 1 and Telco 2 cable pin-out tables in Appendix C,
"Connection pin-out tables."
4 Use Configuration Manager to verify that the following configuration is
correct on the Remote Office 9150 unit, as appropriate:
n IP addresses (Remote Office 9150 unit, subnet mask, and default
gateway, as well as the RLC's IP address, if the IP network is being used
to route calls)
n the telephone number used to establish connections to the RLC, if the
PSTN is being used to route calls
n the security IDs of both the Remote Office 9150 unit and the RLC, if a
security ID is required to authenticate connection attempts
n DNs and SPIDs assigned to the ISDN BRI modules installed in the
Remote Office 9150 unit
n station configuration, to ensure that the telephone you are using has the
calling capabilities needed to complete the tests (that is, verify that the
station is correctly configured as local only, remote only, or both local
and remote)
Note: For instructions on using Configuration Manager, see Chapter 5,
"Configuring the Remote Office 9150 unit."
5 Work with the administrator at the host PBX site to ensure that
n the RLC is enabled and working in its PBX slot (restart the RLC, if
necessary)
n the configuration of the IP address, telephone number, and security ID
on the RLC port are correct (if these items are used)
6 Verify that both the telecom and data networks are routing voice calls as
expected (that is, calls are not being blocked in any way).
What to do if nothing works
If you cannot get the system to work, contact your Nortel Networks distributor
for assistance.
Installation and Administration Guide
Installing the Remote Office 9150 unit
141