Nortel Remote Office 9150 Installation And Administration Manual page 123

September 2001
2 Place the screws in a safe place where they cannot be lost.
3 Ensure the Remote Office 9150 unit is placed top side up.
4 Remove the cover as follows:
a. Grasp both sides of the Remote Office 9150 unit.
b. Slide the cover toward you.
c. Lift the cover off the unit.
d. Put the cover aside.
5 Turn the Remote Office 9150 unit so the rear panel faces you.
6 This allows you to read the labels on the Remote Office 9150 unit circuit
board.
7 Perform module installation as required.
For instructions, see "To install a trunk interface or DSP application module"
on page 103.
8 Replace the cover as described in "To replace the Remote Office 9150 unit
cover" below.
To replace the Remote Office 9150 unit cover
1 Carefully slide the top cover into position over the circuit board so that the
holes along the top edge of the rear panel are aligned.
2 Replace the four screws on the top.
3 Replace the two screws on the sides.
4 Turn the Remote Office 9150 unit over and replace the eight screws on the
bottom.
5 Continue with "Mounting the Remote Office 9150 unit" on page 106.
Installation and Administration Guide
Installing the Remote Office 9150 unit
99