Nortel Remote Office 9150 Installation And Administration Manual page 250

Configuring the Remote Office 9150 unit
To configure stations
1 Locate the port that you want to configure by clicking the appropriate port
range tab, and then scrolling down the list.
The following table describes port number ranges and how they can be
configured:
Ports
0–15 and 32–47
16–31 and 48–63
64
Note: You can use ports 32–47 and 48–63 only if this Remote Office 9150
unit connects to a 2-slot RLC on the host PBX.
2 Under Port Type, click the call processing capability that this station should
have:
n Local: if only calls through the local PSTN are allowed. This option
enables the Configure button for this port.
n Remote: if only calls through the host PBX are allowed.
n Local and Remote: if both local and remote calls and local station-to-
station calling are allowed. This option enables the Configure button for
this port so you can configure local station features and keys.
Note: Choose Local and Remote if you want to define a Bridge Port.
3 Accept the default RLC Port to which this station is assigned, or enter a
new RLC port number.
Exception: Do not associate a local-only port with an RLC port.
226
Can be assigned to
digital telephones.
Note: The associated ports on the host PBX
must be configured with voice capability.
stations equipped with ATAs or MCAs.
Note: The associated ports on the host PBX
must be configured with data capability.
a fax machine or other analog device (without
an ATA).
Note: The associated port on the host PBX
must be configured with data capability.
Standard 2.0
Remote Office 9150