Nortel Remote Office 9150 Installation And Administration Manual page 275

September 2001
Message
Online Mode
Port Already in Use
Port Not Logged In
QoS Recovery
QoS Transition
Release and Try Again
Bandwidth Limit
Installation and Administration Guide
Description
You can place and receive calls through the host PBX.
If this message appears on your station, then your station is
associated with a multi-user or dynamic pool port on the
RLC.
This message appears if the port to which you are
attempting to log on is already being used by someone else.
If this message appears on your station, then your station is
associated with a multi-user or dynamic pool port on the
RLC, but it is in logged off status.
The QoS has returned to normal on the IP network and
your active call is being automatically moved to the IP
network.
The QoS has degraded on the IP network and your active
call is being automatically moved to the PSTN.
All Remote Office 9150 trunks are busy or there are not
enough DSP resources to process the call. Try again at a
later time.
Note: Ensure the call you are placing is initiated from the
appropriate call appearance key:
n
host call appearance key: to call someone at the host
PBX site
n
local call appearance key: to place a local PSTN call or
to call another station at your site
If you see this message and hear a fast busy signal when
you attempt to place a call, then there is insufficient PSTN
bandwidth.
Wait a moment, and then try your call again.
Using Remote Office 9150 stations
251