Nortel Remote Office 9150 Installation And Administration Manual page 110

Planning for installation
1 To implement the QoS transitioning technology, you must understand what
your IP network is doing, such as
n when the busy times are on the network
n how much traffic is processed (during normal and busy traffic periods)
n how to evaluate and adjust your network's Quality of Service
For more details, consult with your data network administrator and refer to
the Remote Office Network Engineering Guidelines (555-8421-103).
2 Once you have this information and understand it, determine what the QoS
settings should be, and then configure them on each RLC port.
For instructions, refer to the Reach Line Card Installation and
Administration Guide (NTP 555-8421-210).
3 If IP mode is the last stage in your network implementation, run this stage
with a minimal number of users until you are sure that your IP network's
Quality of Service is acceptable.
4 When you are satisfied with QoS transitioning performance, deploy the
QoS transitioning capability to the rest of the network.
86
Standard 2.0
Remote Office 9150