Nortel Remote Office 9150 Installation And Administration Manual page 126

Installing the Remote Office 9150 unit
Module type
Trunk interface module
(continued)
The following diagram shows where you can install the trunk interface and DSP
application modules on the Remote Office 9150 unit circuit board:
Nortel Networks recommends that you populate each module position in
sequential order. Install trunk interface modules according to the Telco 1 or
Telco 2 connections used.
102
Valid module positions
Telco 2 connector (phone lines 17 through 32):
n
MOD 6
n
MOD 7
Note: Each Telco connector provides access to
two ISDN BRI lines (each with two B-channels).
Trunk interface modules
Telco 2
6 7
3 2
DSP modules
Telco 1
4 5
1
Standard 2.0
G101408
Remote Office 9150