Utilities - Omron V780-Series User Manual

8-2-7

Utilities

RF Tag Access
Click the Utility Button, and then click the RF Tag access Tab.
A tab page to use RF communications commands to access RF Tags will be displayed. You can use
this tab page to check operation for reading and writing the RF Tag UIIs (EPC codes) or data at any RF
Tag addresses.
Precautions for Correct Use
This tab page cannot be used if the Reader/Writer is started in Safe Mode or SLAVE Mode. Use
this tab page when the Reader/Writer is operating in Run Mode.
Item name
RF communications com-
mand
Data address
Data size
Write data
Command
Repeat
Response
UHF RFID System V780-series Reader/Writer User's Manual (EtherNet/IP
Click this button to send the command
that is displayed in the Command Box.
If you click this button while a
command is being repeatedly sent,
repeatedly sending the command will
be stopped.
Select the command to send.
Setting range: ID read (ID READ), ID write (ID WRITE), Data read (DATA READ),
or Data write (DATA WRITE)
Enter the first RF Tag address to read or write in four hexadecimal digits.
Setting range: 0000 to 3FFF hex
If you specify reading data, enter the data size to read in four hexadecimal digits. If
you specify writing data, the Write data box will display the count of the data size
in four hexadecimal digits.
Setting range: 0001 to 0078 hex
Enter hexadecimal words for the data to write to the RF Tag.
Setting range: 120 words max.
The command to send will be displayed.
Select this check box to repeatedly send the command.
The response from the Reader/Writer will be displayed.
8 Browser Interface
Click this button to delete the information
displayed in the Command/Response Log Area.
Description
TM
) (Z402)
8
8 - 17