Omron V780-Series User Manual page 204

7 Ethernet/IP Communications
SET RSSI FILTER CONDITIONS
Function
This command sets the RSSI filter conditions for the Reader/Writer.
Command Area
Signal/data
CmdCode/Command Code
CmdParam1/Command Parameter 1
CmdParam2/Command Parameter 2
Reserved/Reserved Area
Cnt Response/Update Counter
Response
CmdData/Command Data
RSSI
filter conditions
*1. When you disable the RSSI filter conditions, set the high and low thresholds to 0000 hex.
When you enable the RSSI filter, set the high threshold value for the RSSI filter condition to a higher value
than the low threshold level. Otherwise, a command parameter error will occur.
Response Area
Signal/data
ErrCode/Command Code
RespInfo1/Response Information 1
RespInfo2/Response Information 2
RespInfo3/Response Information 3
Cnt/Update Counter
7 - 52
Data type
WORD
WORD
WORD
WORD
WORD
Enable/dis- WORD
able
HIGH WORD
*1
Threshold
LOW WORD
*1
Threshold
Data type
WORD
WORD
WORD
WORD
WORD
UHF RFID System V780-series Reader/Writer User's Manual (EtherNet/IP
Size
2 bytes 300D hex
2 bytes 0000 hex (Not used.)
2 bytes 0000 hex (Not used.)
2 bytes 0000 hex (Not used.)
2 bytes 0000 hex (At command execution)
The value is counted up due to a change in
the update counter.
For details, refer to Update Counter/Update
Counter Response on page 7-10.
2 bytes Specifies the enable/disable setting of the
RSSI filter.
0000 hex: Disable
0001 hex: Enable
Default setting: 0000 hex
2 bytes Specifies the high threshold for the reception
level.
FFBA to FFF6 hex
(0 or -70 to -10) [dBm]
Default setting: 0000 hex
2 bytes Specifies the low threshold for the reception
level.
FFBA to FFF6 hex
(0 or -70 to -10) [dBm]
Default setting: 0000 hex
Size
2 bytes Error code
2 bytes 0000 hex (Not used.)
2 bytes 0000 hex (Not used.)
2 bytes 0000 hex (Not used.)
2 bytes 0000 to FFFF hex
The value is counted up due to a change in
the response area.
For details, refer to Update Counter/Update
Counter Response on page 7-10.
Function
Function
TM
) (Z402)