Omron V780-Series User Manual page 223

Signal/data
RespData/Response Data
Newest com-
munications
diagnostic
information
*1. When the communications mode is "Repeat", communications canceled/aborted is obtained.
If you want to obtain the information prior to cancellation, refer to the communications diagnosis history on the
Web screen.
*2. Due to size restrictions of the response data, do not set StoredPC + UII (EPC code).
If StoredPC+UII (EPC code) is necessary, issue the GET RF TAG ADDITIONAL INFORMATION command.
*3. Diagnostic processing for these results is performed only in Focus Mode.
Response Area (For Output_111, Output_112, Output_113)
Signal/data
ErrCode/Error Code
RespInfo1/Response Information 1
RespInfo2/Response Information 2
RespInfo3/Response Information 3
UHF RFID System V780-series Reader/Writer User's Manual (EtherNet/IP
Data type
*2
Time infor- ARRAY[]
mation
OF BYTE
Command WORD
code
Error code WORD
Diagnostic WORD
results
Diagnostic WORD
details
Reserved 1 WORD
Reserved 2 WORD
Channel WORD
used
Communi- WORD
cations
Speed
Reception WORD
level
Noise level WORD
Target level WORD
Reserved 3 WORD
Data type
WORD
WORD
WORD
WORD
7 Ethernet/IP Communications
Size
4 bytes Expresses the time information.
(Actual time flag, hour, minutes, and seconds)
2 bytes Expresses the command code.
2 bytes Expresses the error code.
2 bytes Expresses the diagnostic results.
FFFF hex: Error (Set when the error code is
not normal.)
0000 hex: Normal
0001 hex: Insufficient power to send
0002 hex: Insufficient power to receive
0003 hex: Too much noise
0005 hex: Insufficient read data
0006 hex: Excessive read data
2 bytes Expresses the diagnostic details.
Bit 0: Insufficient power to send flag
Bit 1: Insufficient power to receive flag
Bit 2: Too much noise
Bit 3: Reserved
Bit 4: Insufficient data read flag
Bit 5: Excessive data read flag
Bits 6 to 15: Reserved (all zeros)
2 bytes 0000 hex: No specifications
2 bytes 0000 hex: No specifications
2 bytes Expresses the channel used actually during
communications.
0001 to 0064 hex (1 to 100) [CH]
2 bytes Expresses the speed used actually during
communications.
0001 hex: High speed
0002 hex: Normal speed
2 bytes Expresses the reception level.
FFDD to FF9D hex (-35 to -61 [dBm])
2 bytes Expresses the noise level.
FFFF to FF9D hex (-1 to -99 [dBm])
2 bytes Expresses the target level.
0000 to 0064 hex (0 to 100)
2 bytes 0000 hex: No specifications
Size
2 bytes
*1
Error code
2 bytes 0000 hex (Not used.)
2 bytes 0000 hex (Not used.)
2 bytes 0000 hex (Not used.)
TM
) (Z402)
Function
*3
*3
*3
*3
Function
7 - 71
7