Manual Structure - Omron V780-Series User Manual

Manual Structure

Manual Structure
Page Structure
The following page structure is used in this manual.
Level 2 heading
Level 3 heading
A step in a procedure
Indicates a procedure.
Special information
Icons indicate
precautions, additional
information, or
reference information.
Manual name
Note This illustration is provided only as a sample. It may not literally appear in this manual.
10
4-2 Connections and Wiring
4-2-1 Connecting and Removing the Reader/Writer Power Cable and
Ethernet Cable
Power Supply
Connect a power supply that meets the following conditions to the Reader/Writer.
Item Condition
24 VDC −15% to +10%
Supply voltage
Output current 500 mA min.
Safety standard SELV (Safety Extra Low Voltage)
Connecting Method
1
Hold onto the connector on the Power
Cable and insert it into the power connec-
tor on the Reader/Writer.
Precautions for Correct Use
Do not apply more than 30 N of force to the connector on the Reader/Writer.
2
Turn the connector on the Power Cable clockwise
to lock it in place.
• For the Recommended Cable
Turn the cable connector clockwise until you
hear it securely lock in place.
• For Other Cables
Observe the tightening torque specifications for
the cable connectors.
Pin No. Name Description
1 2 4 P + 2 4 V
Control signal (operating mode signal)
*1. Run Mode: Connect to +24 V and
2 CONT
then start the Reader/Writer.
Safe Mode: Connect to 0 V and
then start the Reader/Writer.
3 2 4 N 0 V
4 - - - - - -
Precautions for Correct Use
Pin 4 on the power supply connector is not used. Do not connect it to any terminal.
UHF RFID System V780-series Reader/Writer User's Manual (EtherNet/IP
UHF RFID System V780-series Reader/Writer User's Manual (EtherNet/IP
4 Installation and Connections
4
Reader/Writer Power Connector
Connector on Power Supply Cable
I/O
- - -
IN
- - -
- - -
TM Type) (ZXXX) 4 - 7
Level 1 heading
Level 2 heading
Level 3 heading
Give the current
headings.
Page tab
Gives the number of the
main section.
TM
) (Z402)