Reader/Writer Setting Commands: Device Settings - Omron V780-Series User Manual

7-2-5

Reader/Writer Setting Commands: Device Settings

SET MULTI-READER/WRITER CONFIGURATION
Function
This command sets the multi-Reader/Writer configuration. The settings are enabled from the next
startup.
Command Area
Signal/data
CmdCode/Command Code
CmdParam1/Command Parameter 1
CmdParam2/Command Parameter 2
Reserved/Reserved Area
Cnt Response/Update Counter
Response
CmdData/Command Data
Multi-Reader/Writer Mode
Number of Slave Reader/Writ-
ers
Slave Reader/Writer 1
Slave Reader/Writer 2
...
Slave Reader/Writer 6
Slave Reader/Writer 7
UHF RFID System V780-series Reader/Writer User's Manual (EtherNet/IP
Data type Size
WORD 2 bytes 5003 hex
WORD 2 bytes 0000 hex (Not used.)
WORD 2 bytes 0000 hex (Not used.)
WORD 2 bytes 0000 hex (Not used.)
WORD 2 bytes 0000 hex (At command execution)
The value is counted up due to a change in
the update counter.
For details, refer to Update Counter/Update
Counter Response on page 7-10.
WORD 2 bytes Sets whether the multi-Reader/Writer Mode is
enabled or disabled.
0000 hex: Disable
0001 hex: Enable
Default setting: 0000 hex
WORD 2 bytes Sets the number of Slave Readers/Writers.
0000 to 0007 hex
Default setting: 0000 hex
DWORD 4 bytes Specifies the IP address of Slave
Reader/Writer 1.
Setting range:
00000000 to DFFFFFFF hex
Example) C0A801C9 (192.168.1.201)
Default setting: 00000000 hex
DWORD 4 bytes Specifies the IP address of Slave
Reader/Writer 2.
Setting range:
00000000 to DFFFFFFF hex
Example) C0A801CA (192.168.1.202)
Default setting: 00000000 hex
... ... ...
DWORD 4 bytes Specifies the IP address of Slave
Reader/Writer 6.
Setting range:
00000000 to DFFFFFFF hex
Example) C0A801CE (192.168.1.206)
Default setting: 00000000 hex
DWORD 4 bytes Specifies the IP address of Slave
Reader/Writer 7.
Setting range:
00000000 to DFFFFFFF hex
Example) C0A801CF (192.168.1.207)
Default setting: 00000000 hex
TM
) (Z402)
7 Ethernet/IP Communications
Function
7
7 - 33