Table of Contents
Advertisement
s ample
1
Syntax
Function
Default Values
Parameters
9-78 Timing: Commands
This command specifies the sampling period or rate.
The sample command sets the sampling period or rate for
subsequent measurements. Data is acquired by the analyzer and
stored in trace memory at that effective rate.
The default is the fastest sample rate in each mode.
period_is
This option specifies the sample rate based
on the period.
< PERIOD>
This prompts you to enter the length of the
sample period. The allowed range is 10 nsec
(20 nsec in glitch_capture mode) to 500 msec.
nsec,
These parameters specify the units of
usec,
measurement of < PERIOD> in
msec
nanoseconds, microseconds, or milliseconds,
respectively.
Advertisement
Table of Contents
