Table of Contents
Advertisement
Trace List
Label:
Address
Data
Base:
hex
hex
##########cprg.c - line
/*****************************************/
/* This is a comment block
/* to demonstrate the "number
/* of source lines" trace
/* display option.
/*****************************************/
char *message;
for (;;)
{
message = "This message is to be written indefinitely. ";
+011
000AEA
247C
+012
000AEC
0000
STATUS:
M68000--Running user program
set
source
on
number_of_source_lines 12
pod_cmd
set
perfinit perfrun
Tabs Are. This option allows you to specify the number of spaces
between tab stops so that the appropriate number of spaces can be
inserted for source lines. The default value is eight. Values from
two to 15 can be entered.
Number of Source Lines. Typically, there are lines in the source
file that are not associated with actual instructions (declarations,
comments, etc.). This option allows you to specify the number of
these source lines to be displayed for every source line that is
associated with an actual instruction. Only source lines up to the
the previous source line that corresponds to actual code will be
displayed. The default value is five. Values from one to 50 can be
entered.
Offset=0
More data off screen (ctrl-F, ctrl-G)
Opcode or Status w/ Source Lines
mnemonic
6 thru
17 #################################
MOVEA.L #000000B0C,A2
0000
supr prog
Emulation trace complete______...R....
perfend
*/
*/
*/
*/
Displaying Traces 3-9
time count
relative
480
nS
520
nS
---ETC--
Advertisement
Table of Contents
