Table of Contents
Advertisement
ERROR: Compare not possible on data which is halted
This message appears after you halt a measurement and a compare
file is assigned. Only a completed measurement can be compared
to the compare file data.
ERROR: Configuration file version is not compatible with software
This message indicates that you are trying to use a timing analysis
configuration file with a later data (future version). You need to
check the dates on the system.
ERROR: Configuration load failure
This message appears when the configuration file could not be
loaded due to an interrupt or other HP-UX system problem. You
identify the problem and try to reload the configuration file.
ERROR: Data is not present in hardware
This message appears when you try to save a configuration file
"with_data" but there is no data in the analyzer. You should
execute a measurement before saving the configuration file.
ERROR: Data label < LABEL> bits are already specified
This message is displayed when your trigger specification includes
the same bit or bits in two or more labels. You need to correct the
references.
ERROR: Data label < LABEL> is not a valid entry
This message indicates your trigger specification includes a label
which is not valid for the current mode. You need to correct the
reference.
ERROR: Data label " < LABEL> .xx" specifed bit does not exist
This message is associated with the "process_for_data" command
and appears when you enter a label bit reference that is not one of
the logical bits in that label. < LABEL> is the label name and xx is
the bit number entered. You should choose a correct bit number
reference.
C-6 Timing Messages
Advertisement
Table of Contents
